Curvas Iec 2e702e

3000TC0701 01/2008 LaVergne, TN, USA

Trip Curve IAC-EIT 10PU (1)

where: td = Operate time (sec) I = Current value Is = Current set point A = Coefficient values (see table) B = Coefficient values (see table) C = Coefficient values (see table) D = Coefficient values (see table) E = Coefficient values (see table) T = time setting (sec) at I / Is = 10 β = Coefficient values (see table) NOTES: 1. Sepam™ relays have two modes of setting: The default method shown here, uses curves that are referenced at ten times the current setting (Is)[10 Per Unit]. The alternate method is by TMS, which is similar to an electromechanical time dial setting method. Curves reflecting the TMS method are on a separate form. 2. The following minimum operate thresholds (I / Is) apply: SIT, VIT, LTI, EIT, UIT @ I / Is=1.2 RI, IAC-SIT, IAC-VIT, IAC-EIT @ I / Is=1.0 SIT-A, VIT-B, LTI-B, EIT-C, IEEE MI, IEEE VI, IEEE EI @ I/ Is=1.1 3. When the monitored value is more than 20 times the set point, the tripping time is limited to the value corresponding to 20 times the set point. 4. if the monitored value exceeds the measurement capacity of Sepam™ (40 IN for the phase current channels, 20 INr for the residual current channels), the tripping time is limited to the value corresponding to the largest measurable value (40 IN or 20 INr).

Schneider Electric USA

295 Tech Park Drive, Suite 100 LaVergne, TN, USA 1-888-SquareD (1-888-778-2733) www.us.SquareD.com

10000

1000

Operating Time in Seconds

⎛ ⎞ ⎜ ⎟ T B E D t d ( I ) = ⎜A + ------------------- + ---------------------- + ----------------------⎟ x ----⎛---I- – C⎞ ⎛---I- – C⎞ 2 ⎛---I- – C⎞ 3⎟ β ⎜ ⎝I ⎠ ⎝I ⎝ ⎠ ⎝I ⎠ ⎠ s s s

3000TC0701-IAC-EIT-MT10207b

Extremely Inverse Time 3000TC

100

10 12.5 5 2.5 1.2 0.8 0.4 0.2 0.1

1

0.1

0.01 1

10

100

Current I / Is

Curve Type

Coefficient Values A

B

C

D

E

β

Inverse

0.208

0.863

0.800

-0.418

0.195

0.297

Very inverse

0.090

0.795

0.100

-1.288

7.958

0.165

Extremely inverse 0.004

0.638

0.620

1.787

0.246

0.092

Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel. No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this material. © 2008 Schneider Electric. All Rights Reserved.